Reef board game token box

PLEASE POST A MAKE IF YOU PRINT!

This is a remix of [Kballz](https://www.thingiverse.com/Kballz/about)'s boxes with a couple of modification:

* Original lid would just slide off if you tilted the box even just a little. I added a bump to the box to prevent it from sliding off.
* Box's bottom was a lot ticker then needed, I removed 4 mm of it.
* I extruded "Reef" on the lid for look and to reduce filament usage

Over all about 15-25% less filament use depending on your infill settings.