Thingiverse
Prusa MMU2S filament buffer
by mdjurfeldt
67
Downloads
29
Likes
1
Makes
This is a filament buffer for Prusa i3 mk3s/mmu2s.
The Prusa filament buffer is somewhat awkward to use. It is difficult to get hold of the filament to feed it into the output PTFE tube after inserting it. It is then difficult to feed it forward through long PTFE tubes.
With this buffer, it is easier to insert and feed forward the filament. I also believe that it causes less resistance through friction and has a lower risk of filament breakage for filaments which are sensitive in that resp
The Prusa filament buffer is somewhat awkward to use. It is difficult to get hold of the filament to feed it into the output PTFE tube after inserting it. It is then difficult to feed it forward through long PTFE tubes.
With this buffer, it is easier to insert and feed forward the filament. I also believe that it causes less resistance through friction and has a lower risk of filament breakage for filaments which are sensitive in that resp
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in