Thingiverse
OneWheel bumper protection
by 3D_Corpsman
14
Downloads
5
Likes
0
Makes
When breacking to hard, the OW touches the ground. To Prevent the bumper from getting damaged i designed this thing.
Print with 100% Infill to get maximum lifetime.
Superglue the two screw holder in the wood plate and replace these two screws with 10-32UNF screws 1inch long.
the upper two screws are long enough and need not be replaced.
Print with 100% Infill to get maximum lifetime.
Superglue the two screw holder in the wood plate and replace these two screws with 10-32UNF screws 1inch long.
the upper two screws are long enough and need not be replaced.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in