Thingiverse
30x30 Split Hinge
by JayPeeEss
11
Downloads
13
Likes
0
Makes
A 30x30 Aluminum-compatible hinge which allows the door to be completely removed.
I wanted a hinge which would allow me to open the door normally, but if i wanted greater access to the enclosure (in this case for a 3d printer) I could completely remove the door quickly and without having to remove the hinges.
It uses 8mm steel studding as a pivot-pin (about 40-45mm length is good), glued / epoxy-filled into the top part of the hinge.
There is a raised-slide on the back of the bracket-b
I wanted a hinge which would allow me to open the door normally, but if i wanted greater access to the enclosure (in this case for a 3d printer) I could completely remove the door quickly and without having to remove the hinges.
It uses 8mm steel studding as a pivot-pin (about 40-45mm length is good), glued / epoxy-filled into the top part of the hinge.
There is a raised-slide on the back of the bracket-b
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in