Thingiverse
Snapmaker corner / Eckverbinder for outside filament
by deathworm
8
Downloads
2
Likes
0
Makes
Hello,
my intention was to store the filament outside. Well, the original way from behind the case wasn't good, as I had problems that the filament self got problems with the way.
With this file you can print a new corner with a whole for a 10mm x 10mm pole. two of them left and right and one round in the middle and that filament wheel can perfectly roll.
my intention was to store the filament outside. Well, the original way from behind the case wasn't good, as I had problems that the filament self got problems with the way.
With this file you can print a new corner with a whole for a 10mm x 10mm pole. two of them left and right and one round in the middle and that filament wheel can perfectly roll.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in