Ocie's Duet Wifi Enclosure Box remix for the Full Bear MK3

UPDATE 6/1/2019: I pulled my Z motors, motor holders, and X axis off and used a square on my frame and it was almost completely square (about 0.2mm gap 16" up.) I will most likely make some modifications to this design later that also adds a slot on the back screw so that you can make sure you get it aligned correctly.

UPDATE 5/24/2019: Something I'm a little worried about is the back screw pulling down on the case causing some torque on the Z axis. I'm up to suggestions for fixing this. I kn