Thingiverse
Vention Mini HDMI Splitter Sonoff Shell
by DG5
0
Downloads
0
Likes
0
Makes
Specs:
- 2mm diameter for screw holes the sonoff goes in
- Made for Sonoff 5V Relay Module
- Included gcode is for Ender 3 (ready to print)
Todo 3D-Part before Print:
- Lay flat on bed in Cura
- Rotate body, so the inner lines are parallel to bed edges (See in print-ready [Ender 3] gcode i included in the files)
- Infill 40% is recommended
Todo Sonoff before Assembly:
- Modify/configure your Sonoff SV to operate in so called "isolated mode", picture shown in its wiki page:
- 2mm diameter for screw holes the sonoff goes in
- Made for Sonoff 5V Relay Module
- Included gcode is for Ender 3 (ready to print)
Todo 3D-Part before Print:
- Lay flat on bed in Cura
- Rotate body, so the inner lines are parallel to bed edges (See in print-ready [Ender 3] gcode i included in the files)
- Infill 40% is recommended
Todo Sonoff before Assembly:
- Modify/configure your Sonoff SV to operate in so called "isolated mode", picture shown in its wiki page:
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in