Thingiverse
DuraPi - the "copper top" Assistant
by resnbl
3
Downloads
2
Likes
0
Makes
After printing with a copper-colored lid, I though my case looked like a DuraCell battery...
My only change was to cut down the height of the forward two posts. TBH, I should have either removed them altogether or replaced all four with posts with 3mm holes so I could screw down two and let the HAT support pins rest in the other two.
My only change was to cut down the height of the forward two posts. TBH, I should have either removed them altogether or replaced all four with posts with 3mm holes so I could screw down two and let the HAT support pins rest in the other two.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in