Thingiverse
NEMA 17 Heat Sink and Fan Mount
by simon_fernan
112
Downloads
77
Likes
1
Makes
Original design by [zuberio](https://www.thingiverse.com/thing:3083844).
The design makes use of a 40mm fan and a heat sink with dimensions of 40x40x11.3mm. Just like the original, make use of M3 screws to mount the fan in place. The mount can be used on the motors on the x,and extruder. If mount is loose, having a heat sink adhesive can help keep it on the motor.
When printing, the infill may be as low as 20% but it makes it weak. Higher infill may be desirable because of the design. Asi
The design makes use of a 40mm fan and a heat sink with dimensions of 40x40x11.3mm. Just like the original, make use of M3 screws to mount the fan in place. The mount can be used on the motors on the x,and extruder. If mount is loose, having a heat sink adhesive can help keep it on the motor.
When printing, the infill may be as low as 20% but it makes it weak. Higher infill may be desirable because of the design. Asi
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in