Thingiverse
Self watering pot for vase mode
by TommyUnreal
262
Downloads
166
Likes
0
Makes
# Self watering pot for vase mode
This is project of self-watering flower pot printable in vase mode (single outline or spiralize).
To print this, you are going to need wide nozzle, I used 0.8mm, which is sufficient. Wider nozzle will make the pot more sturdy, with this one it holds just fine. If you need flower pot for outdoor use, I strongly recommend to print this project with UV resistant filament like ASA.
Print both parts. Original size is 170mm high and 170mm wide when assembled
This is project of self-watering flower pot printable in vase mode (single outline or spiralize).
To print this, you are going to need wide nozzle, I used 0.8mm, which is sufficient. Wider nozzle will make the pot more sturdy, with this one it holds just fine. If you need flower pot for outdoor use, I strongly recommend to print this project with UV resistant filament like ASA.
Print both parts. Original size is 170mm high and 170mm wide when assembled
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in