Thingiverse
CL1 rear VTX antenna mount
by pano_maniac
17
Downloads
6
Likes
0
Makes
Just a simple rear mount for a VTX antenna for the CL1 frame by rotor riot. I made this since my frame had no way of mounting the antenna.
I used a cheap TPU and the fit onto the frame is noice and snug. No fear of this sliding up and down the spacers. The hole for the antenna has some wiggle room (8mm) but a washer should suffice if it's too large for you.
This piece is plenty rigid but with some small amount of flex in case of a hard crash.
After a good few crashes it's held up nice
I used a cheap TPU and the fit onto the frame is noice and snug. No fear of this sliding up and down the spacers. The hole for the antenna has some wiggle room (8mm) but a washer should suffice if it's too large for you.
This piece is plenty rigid but with some small amount of flex in case of a hard crash.
After a good few crashes it's held up nice
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in