Thingiverse
Bicycle stem based gopro mount
by thmjpr
5
Downloads
7
Likes
0
Makes
Two piece mount to attach to road bicycle stem.
Some stems are different profiles, but this worked on an Uno 7 70mm stem, as well as Deda Zero stem.
Size 8-32 and hex nut fit ok.
Put foam tape on the bottom and top in the center where the plastic meets the stem if possible, to avoid the clamp sliding around.
The photo is of a hero session attached to the mount.
Some stems are different profiles, but this worked on an Uno 7 70mm stem, as well as Deda Zero stem.
Size 8-32 and hex nut fit ok.
Put foam tape on the bottom and top in the center where the plastic meets the stem if possible, to avoid the clamp sliding around.
The photo is of a hero session attached to the mount.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in