Hall sensor Ender 5

This is the Z Hall endstop for Ender 5, or other. It's made for 2020 profile, and to rotate the plug on 90 degree.
For reference see the pic.
There are 2 M3 holes inside the case to screw the board, but it is actually not needed.
All components should be soldered from the traces side, except for 3 pin connector.

Switch time from 0V to 5V - 1.52 microseconds
Rise time 725 nanoseconds (see pics)

If the total thickness of the bed is about 6mm - no adjustment needed.
You will need 5*2mm