Thingiverse
Railcore II 300ZLT Filament Spool Holder Side Mount
by jevs
32
Downloads
15
Likes
2
Makes
Side mount filament spool holder for the Railcore II 300ZLT. This fits existing holes. The hole in the top is sized for an 1/8" NPT tap to put an NPT tube holder fitting. I am sure other types could be adapted.
Top two screws are 3x20mm button head. The bottom is a 3x16 button head. All captured with an M3 nut or you could use a Nylock nut if you wanted.
Depending on where you had your Z stepper wires ran, you may need to move them over a little.
*Note: Added a mirrored version per
Top two screws are 3x20mm button head. The bottom is a 3x16 button head. All captured with an M3 nut or you could use a Nylock nut if you wanted.
Depending on where you had your Z stepper wires ran, you may need to move them over a little.
*Note: Added a mirrored version per
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in