Thingiverse
Ball Joint small 5mm ball
by bonesy91
11
Downloads
12
Likes
0
Makes
may want to print with a brim. this was a test to see how small of a ball joint socket I could make using the default nozzle on the prusa i3 mk2s (0.4mm)
after doing research I found that 2 wall thickness was needed to insure the strength of the snap fit joint. to achieve this, make sure the thickness of the wall is at least 0.86mm. this with the settings in prusa slicer set to 0.15 creates two line thickness of said walls.
Just a test but also wanted to share in case if anyone else was c
after doing research I found that 2 wall thickness was needed to insure the strength of the snap fit joint. to achieve this, make sure the thickness of the wall is at least 0.86mm. this with the settings in prusa slicer set to 0.15 creates two line thickness of said walls.
Just a test but also wanted to share in case if anyone else was c
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in