Thingiverse
Anet A8 Auto Shutdown the easiest way
by lompyka
41
Downloads
31
Likes
0
Makes
The easiest way to equip your printer with the auto power off capability.
You don't need to print anything for this solution, at least one 3D fiile needed to publish this, thats why the mutyur.stl is in the project.
Ingredients:
- a two pole switch (if you don't have until now)
- a Relay with 5 VDC coil and with 2 pole 5A 250 VAC Normaly Open contacts,
I used the Omron G6B-2214P type,
- a diode (flywheel diode to protect your board from the relay)
- ~50 cm twin cable
You don't need to print anything for this solution, at least one 3D fiile needed to publish this, thats why the mutyur.stl is in the project.
Ingredients:
- a two pole switch (if you don't have until now)
- a Relay with 5 VDC coil and with 2 pole 5A 250 VAC Normaly Open contacts,
I used the Omron G6B-2214P type,
- a diode (flywheel diode to protect your board from the relay)
- ~50 cm twin cable
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in