Thingiverse
Alliance & Horde Symbols (Side-by-Side)
by Apex-3D
35
Downloads
25
Likes
0
Makes
-Printed with the Creality CR-10 @ 0.2mm Layer Height
-Top/Bottom Layers - 3 each
-Did not use any support
-Used Brim for Build Plate Adhesion with 5 lines
-Print speed was 60mm/s
-This model can be scaled as needed on any axis
-The infill was set at 10% but can be any desired amount.
-Print time will vary based on the desired scale
-Top/Bottom Layers - 3 each
-Did not use any support
-Used Brim for Build Plate Adhesion with 5 lines
-Print speed was 60mm/s
-This model can be scaled as needed on any axis
-The infill was set at 10% but can be any desired amount.
-Print time will vary based on the desired scale
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in