Thingiverse
Eggtimer Sled BT55
4
Downloads
7
Likes
0
Makes
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/6OQiYlPEzfQ
Printed with 30% infill. PLA Use supports, no raft needed, you will have to dig out the supports where the tiny hex nuts go...
Slides into BT-55 as is, room for Lipo battery underneath.
Large mounting holes for attachment to larger AV Bay. Use Button Head M3 or M4
Small holes for #1 x72 Socket head hex screws.
Optional: drill 2 x 1/8" holes on flat area by left end of sled for cable tie holding
Printed with 30% infill. PLA Use supports, no raft needed, you will have to dig out the supports where the tiny hex nuts go...
Slides into BT-55 as is, room for Lipo battery underneath.
Large mounting holes for attachment to larger AV Bay. Use Button Head M3 or M4
Small holes for #1 x72 Socket head hex screws.
Optional: drill 2 x 1/8" holes on flat area by left end of sled for cable tie holding
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in