Thingiverse
Spice rack
110
Downloads
95
Likes
2
Makes
This is a spice rack which uses 1/4" (6.35mm) dowels. There is a slot on the back side of the bracket so it mounts flush when using a 3M Command Strip. The brackets are narrow so the command strip needs to be cut in half lengthwise. If you don't have any Command Strips, any double-sided foam adhesive tape should work.
It should fit all standard size spice jars.
Directions:
1. Print one of each side
2. Cut 3 dowels to the same length
3. Glue the dowels into the holes (I used hot glu
It should fit all standard size spice jars.
Directions:
1. Print one of each side
2. Cut 3 dowels to the same length
3. Glue the dowels into the holes (I used hot glu
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in