Thingiverse
The Pegboard Project
70
Downloads
51
Likes
0
Makes
Yes, I know that pegboard has been done. Now it has been done again. And in such pretty colors !!.
I got the basic pegs design in SCAD for here:
https://www.thingiverse.com/thing:1997501
And then made custom SCAD code for each of the holders that were not screwdrivers.
the pegboard I did in parameterized SCAD.
I may be able to print bigger than 6x6, but I was thinking that 3 of them would fit into the 18 inch stud to stud spacing in my house. There are screw holes and wall offsets int
I got the basic pegs design in SCAD for here:
https://www.thingiverse.com/thing:1997501
And then made custom SCAD code for each of the holders that were not screwdrivers.
the pegboard I did in parameterized SCAD.
I may be able to print bigger than 6x6, but I was thinking that 3 of them would fit into the 18 inch stud to stud spacing in my house. There are screw holes and wall offsets int
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in