Thingiverse
Wheel Stand Pro Extension
by aterfax
2
Downloads
2
Likes
0
Makes
A small extension to the largest wheel stand pro platform to add a spot below the keyboard for a tablet or small laptop (Surface Pro) and two 120mm fans.
Offset behind the pillars is to account for my K50 keyboard palm rest. Pillars are raised to get a better angle to the screen and raise it above the keyboard so WASD and other keys are still accessible.
This is 4.4mm thick on the base, 25 cm in length, 16.5 cm in width.
Print was 25% infil with 2mm at 100% on top and bottom.
Design
Offset behind the pillars is to account for my K50 keyboard palm rest. Pillars are raised to get a better angle to the screen and raise it above the keyboard so WASD and other keys are still accessible.
This is 4.4mm thick on the base, 25 cm in length, 16.5 cm in width.
Print was 25% infil with 2mm at 100% on top and bottom.
Design
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in