375mm folding quadcopter frame

All pieces are meant to be laid flat so that they are printed with the most strength possible. I've chamfered some bottom edges to make it easier to put together some of the piece as well. The holes on the front edge of the rear top plate are meant to hold the GPS and FPV antenna, the circle is the right size to fit a SMA connector while the other side planned to have another piece slide through and secured with a zip-tie to hold the GPS, however after making this one, I've decided to move those to another plate on the next version. The next version will likely have longer front arms, a thinner and shorter middle section, and a removable gimbal mount for storage and travel (for my model of gimbal, Tarot T4-3D, but hopefully can be adapted for others of similar size).

Printing guide:
Front Side Clip - 4x
Front Top and bottom half plate - 2x normal, 2x mirrored
Rear bottom plate - 1x
Rear top plate - 1x
Rear side - 2x
Rear corner - 2x
Landing gear side - 4x normal, 4x mirror