Thingiverse
Amiga Gotek OLED 128x64 0.96" display with rotary encoder
by Bokoshi
75
Downloads
57
Likes
0
Makes
Amiga 500 128x64 0.96" OLED display case utilising a rotary encoder.
Mounts to grill on the rear of the Amiga 500 (measured for PAL A500)
I found the best way to print this was to have the face down.
To get the pins to sit 90' I bent them with the plastic locator in place, then broke up the locator with flush cut wire snips. Care must be taken as you can easily break the board or screen.
The retaining clip does not touch the OLED display, you need to use foam tape to help secure it.
Mounts to grill on the rear of the Amiga 500 (measured for PAL A500)
I found the best way to print this was to have the face down.
To get the pins to sit 90' I bent them with the plastic locator in place, then broke up the locator with flush cut wire snips. Care must be taken as you can easily break the board or screen.
The retaining clip does not touch the OLED display, you need to use foam tape to help secure it.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in