Thingiverse
Sculpture 7
by PalRas
6
Downloads
6
Likes
0
Makes
A small and slightly fragile model.
I started with a globe and cut out a slice at the equator.
I have manipulated it a bit: split in half and quarter and put the pieces together again.
It is eventually placed on a small plate.
NOTE: If it is printed upright, a lot of support material must be used. It can be significantly reduced if the model is placed on the side.
I started with a globe and cut out a slice at the equator.
I have manipulated it a bit: split in half and quarter and put the pieces together again.
It is eventually placed on a small plate.
NOTE: If it is printed upright, a lot of support material must be used. It can be significantly reduced if the model is placed on the side.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in