Thingiverse
38 pin Esp32 Case
von danilonlima
24
Downloads
20
Likes
0
Makes
Please, leave a comment if this worked for you.
A simple case for the Esp32 DevKit of the model in the picture, with 38 pins. and standoff holes.
INFO: The weakest part of the print are the standoff pins, however, they are not really needed, two can break but the case will work just the same because there's a "bed" on the inside for the board.
Created in Thinkercad
A simple case for the Esp32 DevKit of the model in the picture, with 38 pins. and standoff holes.
INFO: The weakest part of the print are the standoff pins, however, they are not really needed, two can break but the case will work just the same because there's a "bed" on the inside for the board.
Created in Thinkercad
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
