Thingiverse
3-axis printer dimension calibration and supporting documentation
by mk_tx
17
Downloads
11
Likes
0
Makes
This is an accurate solution for calibrating your printer's steps/mm for X, Y, and Z (but not E).
Everything isn't actually bigger in Texas, all measuring devices are incorrectly calibrated in Texas. And if you think that's funny, then this is the right post for you, fellow standards enthusiast!
Most printer dimension calibrations are taken from a single measurement. If you only take one measurement for each axis, such as with a cube, the measurement can be biased by your extrusion param
Everything isn't actually bigger in Texas, all measuring devices are incorrectly calibrated in Texas. And if you think that's funny, then this is the right post for you, fellow standards enthusiast!
Most printer dimension calibrations are taken from a single measurement. If you only take one measurement for each axis, such as with a cube, the measurement can be biased by your extrusion param
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in