Thingiverse
8mm shaft collar
by jc61990
40
Downloads
31
Likes
1
Makes
Printed collar made to fit any 8mm smooth rod.
I used this specifically on my Printrbot Spool holder in place of the crappy wood one that would always fall off.
Just need one 3mm nut and a M3 x 10mm screw, I used one of the screws that held the two halves of the wood collar together.
Print with 2 shells and minimal infill. I got away with 15%.
It should be a snug fit.
I used this specifically on my Printrbot Spool holder in place of the crappy wood one that would always fall off.
Just need one 3mm nut and a M3 x 10mm screw, I used one of the screws that held the two halves of the wood collar together.
Print with 2 shells and minimal infill. I got away with 15%.
It should be a snug fit.
Sign in to leave a comment
Sign in