Geeetech A10M filament guide - Remix for Spool holder bracket 50mm shift thing:3520218

I was trying to use the initial design, but since I am using my 50cm spool shift to align the middle of the spool with the inlet of the extruder, I had to re-design the holder for the roller. This now is a symmetric design requiring 2 roller each of the original thing (https://www.thingiverse.com/thing:3326123).
It is also improved so the wiring for the filament runout sensor can be better guided.
If you are not using the sensor you can also use this holder by bending the sensor 90 degrees sid