Thingiverse
Gcode for manual bed-leveling Kossel
by Coat
30
Downloads
20
Likes
0
Makes
Procedure in Gcode for manual bed-leveling your Kossel. Comes in 6 flavours: Hot and cold bed/nozzle and 3 different bed-sizes (240, 220 and 180).
Update: 25-Oct-2019: Pyz and Pzx were swapped in earlier version. Doesn't influence the outcome but it is repaired.
The Gcode is meant for Kossels with three leveling-point in the middle between the towers. If you have the leveling-points at the corners, see note 1 below.
The codes does not print anything, only intended to adjust the bed. Sta
Update: 25-Oct-2019: Pyz and Pzx were swapped in earlier version. Doesn't influence the outcome but it is repaired.
The Gcode is meant for Kossels with three leveling-point in the middle between the towers. If you have the leveling-points at the corners, see note 1 below.
The codes does not print anything, only intended to adjust the bed. Sta
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in