CNC Controller Motor Parallel Wiring Board
by Rhaum
2
Downloads
1
Likes
0
Makes
Just a simple board to organize the wiring of 2 steppers for each the X and Y axis on my CNC, as well as a place to connect my industrial endstops (that are on 12ga wire).
I used terminal blocks like these (https://www.amazon.com/gp/product/B077VMH97C) both on this board cut in sections of 4, and on the stepper motors themselves, and ran 4 conductor cable from MPJA (https://www.mpja.com/4-Conductor-Cable-25ft/productinfo/32551+WI/) between them, making a very secure, and inexpensive setup.
I used terminal blocks like these (https://www.amazon.com/gp/product/B077VMH97C) both on this board cut in sections of 4, and on the stepper motors themselves, and ran 4 conductor cable from MPJA (https://www.mpja.com/4-Conductor-Cable-25ft/productinfo/32551+WI/) between them, making a very secure, and inexpensive setup.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in