Unsinkable toy boat II
by R3ft
15
Downloads
16
Likes
0
Makes
What is even better than pulling a toy boat on a rope? Exactly, having it done by an outboard motor.
This one has been designed to be used with the playmobil outboard motor 5159. The mounting is clipped in the slot at the boat´s rear and then fixed with a screw(you should use a shorter one than I did).
Print the boat using support nose pointing upwards, so inside the boat support is only necessary for the hole which is used to fix the engine mounting. The boat´s rear angle is ten degrees, so r
This one has been designed to be used with the playmobil outboard motor 5159. The mounting is clipped in the slot at the boat´s rear and then fixed with a screw(you should use a shorter one than I did).
Print the boat using support nose pointing upwards, so inside the boat support is only necessary for the hole which is used to fix the engine mounting. The boat´s rear angle is ten degrees, so r
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in