Thingiverse
Blackhawk Lowboy 3 Switch Mount
by doenute
2
Downloads
3
Likes
0
Makes
This 3D print is useful for relocating the run/start switch on the Aero 1000 engine powering a Lowboy 3 quad powered Paraglider.
Additional parts required are:
2 pieces M4 X 25mm SHCS
2 pieces M4 X 40mm SHCS
4 pieces Heat set inserts: McMaster-Carr 94180A353
The heat set inserts are applied with a soldering iron into pockets on the back of the clamp to receive the cap screws.
Additional parts required are:
2 pieces M4 X 25mm SHCS
2 pieces M4 X 40mm SHCS
4 pieces Heat set inserts: McMaster-Carr 94180A353
The heat set inserts are applied with a soldering iron into pockets on the back of the clamp to receive the cap screws.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in