Thingiverse
PolarityGear Fidget Toy
by HoldenArt
11
Downloads
9
Likes
0
Makes
A newer, BETTER, FDM tested, tried and true fidget toy design with the same behavior is here: https://www.thingiverse.com/thing:5667825
The page you're on is an older design and it does not work well for FDM printers. Even MJF printing might require that you shave-off some of the material around the edge for magnets to fit. Try the referenced design mentioned above for best results with any type printer and any resolution.
This is a toy that requires 2 Polymagnets from CMR and a snap rin
The page you're on is an older design and it does not work well for FDM printers. Even MJF printing might require that you shave-off some of the material around the edge for magnets to fit. Try the referenced design mentioned above for best results with any type printer and any resolution.
This is a toy that requires 2 Polymagnets from CMR and a snap rin
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in