Microscope Bolt On Lamp

This is a DIY Bolt-On Lamp for microscopes. This uses three LEDs and a potentiometer to illuminate the top of a slide. The print is bolted to the microscope neck, so that the LEDs point down onto the slide.

Parts:
Resistor
Potentiometer
Barrel Jack
3 LEDs
2 M4 Bolts and Matching Nuts
4 Screws

The circuit schematic is up to you, since you can use any three LED's you want. I will be printing one for white, RGB, and UV so that I can illuminate with any part of the spectrum.

The pot