Thingiverse
Dual Extrusion Motor Mount - Ender 3, CR-10, etc - NO HARDWARE REQUIRED!
by markarsenich
34
Downloads
14
Likes
0
Makes
Add an extruder to the left side without having to buy any hardware and without making any major modifications!
I printed the original and went to install it only to find the I needed longer screws, which I did not have. So I threw this together and beefed it up as well. You can see a side by side comparison in the photos.
I printed this in PETG
NO SUPPORTS NEEDED
Install: I basically took the top screw out, then replaced, then the bottom screw and replaced, this way I felt like I di
I printed the original and went to install it only to find the I needed longer screws, which I did not have. So I threw this together and beefed it up as well. You can see a side by side comparison in the photos.
I printed this in PETG
NO SUPPORTS NEEDED
Install: I basically took the top screw out, then replaced, then the bottom screw and replaced, this way I felt like I di
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in