Hypercube Evolution X-Carriage modified

This is a modified Hypercube Evolution Carriage.
It should fit a setup with 10mm carbon tubes and 19mm bearings on them.

i didnt like the tightening of the belts in most versions so i added those angled holes.
put the belt through them and the GT2 Belt Negative should hold it (put a long M3 screw through it and a little M3 insert nut).

i was only able to print the GT2 Belt Negative with simplify3d - cura made the walls to thin - and there is not much wall anyway.

various versions of t