Thingiverse
Tarantula Pro 350W PSU
by jimwooly
13
Downloads
7
Likes
0
Makes
This is a cover to enable the use of a 350W power supply in the Tarantula Pro and incorporate Auto Switch On and Off using the M80 command in the startup script & M81 in the end script.
A 2mm strip needs trimming off the RH edge of the power supply from the front to the edge of the top cover (About 15mm long). This is to prevent the PSU/Cover fouling the Y end stop assembly.
The relay unit used is a 5volt module from Aliexpress :- https://www.aliexpress.com/item/32719754159.html?spm=a2g0o.
A 2mm strip needs trimming off the RH edge of the power supply from the front to the edge of the top cover (About 15mm long). This is to prevent the PSU/Cover fouling the Y end stop assembly.
The relay unit used is a 5volt module from Aliexpress :- https://www.aliexpress.com/item/32719754159.html?spm=a2g0o.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in