Thingiverse
SIM racing tablet mount
by postmaster11
181
Downloads
151
Likes
0
Makes
Made this for a friend's SIM racer.
Tablet mount is based on this design: https://www.thingiverse.com/thing:3033578
Ball ends are based on this design: https://www.thingiverse.com/thing:1282392
Seems pretty strong and holds even this huge tablet.
Used a M8 threaded bar between the ball ends.
4x 3x 20mm screws for stoppers
M8 screw for the arm
M5 screw and nut for holding the mount
M4 screw and nut for the slider
large washer below the arm, smaller one that fits into top of a
Tablet mount is based on this design: https://www.thingiverse.com/thing:3033578
Ball ends are based on this design: https://www.thingiverse.com/thing:1282392
Seems pretty strong and holds even this huge tablet.
Used a M8 threaded bar between the ball ends.
4x 3x 20mm screws for stoppers
M8 screw for the arm
M5 screw and nut for holding the mount
M4 screw and nut for the slider
large washer below the arm, smaller one that fits into top of a
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in