MKS Gen V1.2 Board Enclousure
3
Downloads
1
Likes
1
Makes
Designed this enclousure for a helloBeePrusa which uses a MKS Gen V1.2 board.
The structure screws are the same which bolts the board or you can add up spacers from the back.
I included a hole for a PG11 cable gland on top and a place for a magnet to hold the door closed.
Two fans 40x40 were added on the door to keep the drivers cooldown.
USB port cut-out included to allow conection to PC with the door closed.
The structure screws are the same which bolts the board or you can add up spacers from the back.
I included a hole for a PG11 cable gland on top and a place for a magnet to hold the door closed.
Two fans 40x40 were added on the door to keep the drivers cooldown.
USB port cut-out included to allow conection to PC with the door closed.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in