Flat test square
by Toothfairy_
39
Downloads
22
Likes
0
Makes
This is just a flat square, to test the bed level.
In Cura, put it int the middel and save it as a standard quality 0.2mm
There's a 1 layer of 0.2mm and a 5 layer of 0.2mm
Print it out in the middle of the bed.
The print should be consistent and flat.
When this it pretty ok, you can start with your auto bedleveling procedure.
In Cura, put it int the middel and save it as a standard quality 0.2mm
There's a 1 layer of 0.2mm and a 5 layer of 0.2mm
Print it out in the middle of the bed.
The print should be consistent and flat.
When this it pretty ok, you can start with your auto bedleveling procedure.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in