Thingiverse
Ducks Foot
by Unknown
32
Downloads
26
Likes
1
Makes
Ducks Foot. Why ? I don't know.. just look like someting I should make,
I used Sculptris and Lightwave 3D to make the Mesh and Meshmixer to clean it up and make the stl. I Printed it on my newly updated printerbot simple (1405) I have not updated the firmware yet so i printed on a slightly unlevel printhead. thus the "stringy" bottom layer seen in the photo.
I used Sculptris and Lightwave 3D to make the Mesh and Meshmixer to clean it up and make the stl. I Printed it on my newly updated printerbot simple (1405) I have not updated the firmware yet so i printed on a slightly unlevel printhead. thus the "stringy" bottom layer seen in the photo.
Sign in to leave a comment
Sign in