Thingiverse
Lithophane Lamp
by jonnygr
16
Downloads
13
Likes
0
Makes
This is a lithophane lamp I designed for my Great Great Aunt's 100 birthday!
I printed it out of wood PLA, but you could use any PLA.
The base has a cut out for an E17 bulb holder which I glue in place. I used a small 7W LED bulb so the bulb was about at the centre of the lamp.
The lithophanes were created using the site http://3dp.rocks/lithophane/
First I cropped the photos to a 10x8 ratio. The important settings in the Lithophane generator were:
Max size: 119
Thickness: 3
Border
I printed it out of wood PLA, but you could use any PLA.
The base has a cut out for an E17 bulb holder which I glue in place. I used a small 7W LED bulb so the bulb was about at the centre of the lamp.
The lithophanes were created using the site http://3dp.rocks/lithophane/
First I cropped the photos to a 10x8 ratio. The important settings in the Lithophane generator were:
Max size: 119
Thickness: 3
Border
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in