3D Bag Clip

This is a simple bag clip designed for a bread bag. It has a fun 3D tactile design which is great for printing on a 3D printer.

To use it, give the bag end a couple twists and then slip the wide end of the clip over the twisted portion, then pull the bag end over and through the hole closest to the bag end. Then give the clip a twist clockwise to seat the bag into other side of the clip and, with the bag through both holes, pull the clip toward the bag to make a super seal.

It uses around 3g (0.86m) of filament and takes about 30 min when printing just a single one. If you're using PETG then I would recommend printing really slowly (i.e. 30mm/s).