Thingiverse
3d Printable Dwarven Chain
door Rawrbomb
77
Downloads
71
Likes
0
Makes
3d printable Dwarven Chain. These are printed flat, and must be assembled. Works well as a typical 4 in 1 pattern. The Rings are about 2cm wide.
The rings are printed in sets with a tiny bit of connective plastic between them so they adhere better to a build plate. You can snap these apart, or cut them.
I have only printed these with ABS, PLA might be too brittle to open up and snap together.
Included are 8 sided and 6 sided rings. The 6 sided are simpler. The 8 sided have engraved runes in them for a more detailed print. These print ok on my .5mm nozzle. The 8 sided rings you will need an exacto knife to snip half the rings so they can be weaved together.
I've added a "starter row" that you can print that makes the initial weaving of the rings a bit easier.
The rings are printed in sets with a tiny bit of connective plastic between them so they adhere better to a build plate. You can snap these apart, or cut them.
I have only printed these with ABS, PLA might be too brittle to open up and snap together.
Included are 8 sided and 6 sided rings. The 6 sided are simpler. The 8 sided have engraved runes in them for a more detailed print. These print ok on my .5mm nozzle. The 8 sided rings you will need an exacto knife to snip half the rings so they can be weaved together.
I've added a "starter row" that you can print that makes the initial weaving of the rings a bit easier.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!