Thingiverse
Engineering
Ver Modelo
3D Printed Centrifugal Pump
19
Descargas
17
Likes
0
Makes
**July 19, 2017 I will add build instructions soon**
The following is centrifugal pump I designed for an engineering project of mine. All of the assembly was printed with a Markforged Mark Two except for the L brackets that support the box structure, the drive shaft, ball bearings, shaft couple, hardware, and the DC motor.
To seal the pump I used liquid gasket maker and petroleum jelly
3D printed parts were made with nylon reinforced with fiberglass or nylon reinforced with carbon fiber.
The following is centrifugal pump I designed for an engineering project of mine. All of the assembly was printed with a Markforged Mark Two except for the L brackets that support the box structure, the drive shaft, ball bearings, shaft couple, hardware, and the DC motor.
To seal the pump I used liquid gasket maker and petroleum jelly
3D printed parts were made with nylon reinforced with fiberglass or nylon reinforced with carbon fiber.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
