Thingiverse
3D Printed Circuit
von wesman732
15
Downloads
20
Likes
0
Makes
I am attempting a 3D Printed circuit. I painted this model with conductive glue and I used a wire to attach a CR2032 battery. Many ATTINY chips can be programing using the Arduino IDE.
See http://www.arduino.cc/
http://highlowtech.org/?p=1695
Use Arduino as ISP or In Circuit Programmer.
I tried Makergeeks conductive ABS but is has high resistance so a conductive paint or paste had to be used.
Attiny84 Datasheet:
http://www.atmel.com/Images/doc8006.pdf
At 3V resistors are not really needed to limit current for LED. I tried to use SMT led but I could not get a good connection.
Just learning AutoCAD Inventor and this is my first project. Hopefully more to follow.
See http://www.arduino.cc/
http://highlowtech.org/?p=1695
Use Arduino as ISP or In Circuit Programmer.
I tried Makergeeks conductive ABS but is has high resistance so a conductive paint or paste had to be used.
Attiny84 Datasheet:
http://www.atmel.com/Images/doc8006.pdf
At 3V resistors are not really needed to limit current for LED. I tried to use SMT led but I could not get a good connection.
Just learning AutoCAD Inventor and this is my first project. Hopefully more to follow.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!