Thingiverse
3D-Printed Combination Lock
von ROBK636
403
Downloads
496
Likes
2
Makes
http://blog.makezine.com/archive/2009/05/3d-printed_combination_lock.html
http://www.instructables.com/id/3D-Printed-Combination-Lock/
This was for a final project for my 3D modeling class. I went with a Combo lock. It was done to show how a basic combo lock works. Total size is 4 inches wide. 3.5 front to back and 2.5 tall and is made of 10 parts.
I was going to do a Anniversary release of the files, but I am releasing it sooner because I get asked every once in a while about the .STL files or the Inventor.IPT files so here you go. Enjoy.
Inventor IPT files are for Inventor 2009
http://www.instructables.com/id/3D-Printed-Combination-Lock/
This was for a final project for my 3D modeling class. I went with a Combo lock. It was done to show how a basic combo lock works. Total size is 4 inches wide. 3.5 front to back and 2.5 tall and is made of 10 parts.
I was going to do a Anniversary release of the files, but I am releasing it sooner because I get asked every once in a while about the .STL files or the Inventor.IPT files so here you go. Enjoy.
Inventor IPT files are for Inventor 2009
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
