3D Printed DC Motor/Generator

Hello everyone, available to print is a simple yet effective DC motor. For optimal RPM's, I would print the armature and shaft as light as possible, 1.2 mm walls and 10% infill. You will need the materials below to build it. For additional support, please use the following video link:
https://www.youtube.com/watch?v=vz3DLgWqSBY&feature=youtu.be

4.5 - 5 meters of 22 gauge magnetic wire
2 x 22 gauge solid jumper wires stripped back 2-3 cm
2 x M4 counter sink bolts and nuts
32mm or 1.26 diameter neodymium magnets
3D Printed Rotor, armature, drive shaft, and commutator
3D Printed Motor Platform or Base
Alligator clip wires
Small piece of sand paper
Multimeter

Assignment Instructions link: https://docs.google.com/document/d/10RfJQUC75f35oriDNkn3UcM94wlSgQMLpBUgYVlsIuU/edit?usp=sharing