Thingiverse
3D Printed Easter Basket
von OpenScadDad
63
Downloads
74
Likes
0
Makes
The basket printed flat. I printed the bail on its side starting with a brim.
Every other ring of the basket gets rotated 180 degrees around. The slots in each ring accept the ring above it. It's clear where each ring goes and where you need to apply glue. I recommend CA glue or epoxy.
The basket's base is quite small and so it's easy to tip over. You may want to add some feet or other feature to increase stability.
https://youtu.be/BJfqohr92jA
Every other ring of the basket gets rotated 180 degrees around. The slots in each ring accept the ring above it. It's clear where each ring goes and where you need to apply glue. I recommend CA glue or epoxy.
The basket's base is quite small and so it's easy to tip over. You may want to add some feet or other feature to increase stability.
https://youtu.be/BJfqohr92jA
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
