3D printed speaker- V3

** IMPORTANT**
This speaker's components were printed on a resin printer they are small and some of the walls are .2mm or smaller it may not print proper on a FDM style printer use at your own risk.

This is the basic components of a 3D printed speaker, you need to add magnets and copper wire.

The Spider and Surround should be printed in TPU or this speaker may not work. I used Ninja flex 85A but it should work with everything up to 97A it will just change the frequency response (higher shore hardness = high frequency response-- 85A will act like a small woofer and 97A should act like a mid)

Magnets are 8mm OD x 2.5mm H- you need 12, The magnet wire on the coil is .25mm OD My speaker is wired for 4 OHMs please refer to the manufacture spec for ohm per 1000 ft and then do some conversion math to get you're desired OHM rating.


*** MAKE SURE YOUR AMP IS RATED FOR THE OHM YOU'RE WIRING FOR**

you can always wire higher than your amps rated OHM but never lower

This spe